Class Reunion - Class of 1969 - Liberty, Mississippi
Brother, if the original two (one red and one is just the switch line of the control lamp), it can't be connected to the socket theoretically. Because there is no zero line in that line, one is the live line, the other is the control line to the lamp.
However, if you really want to connect, in line with the following circumstances can be achieved, a little nonsense! I never recommend it!
1. When the switch is closed, the light is on; the socket has power, but the potential is the same, so it is not available!
2. If the switch is disconnected, the socket is electrified (the voltage is lower than 220 V in theory). If the electric equipment is plugged in, the light will be on, and the Stainless Steel Drawer Slides electrical equipment can work.
First of all, because the diameter of lighting circuit is generally small, it is not suitable for large power electrical equipment.
Secondly, when using low-power equipment, the wattage of the lamp should not be too high, otherwise the partial voltage is too high, the voltage on the socket will be low, and the phenomenon of "no moving" may occur.
Specific wiring: (randomly find a picture)
if there are only two wires, then I'm sorry, your idea is not easy to realize, there are no lines.
In addition, connect a zero line to one of the plug-in holes of the socket. The original two wires are connected to the switch, and then the hot wire of the switch is connected to the socket with a short line. Never connect as the picture of the man of grade seven, which will be short circuited!!!Kitchen Cabinet Hardware Suppliers
There are zero line and Fitting Cabinet Hingesfire line inside, as well as the control line that can control the lamp!
The switch controls single line, and the socket must be double wire